Advanced Instrumentation and Process Control Course

From Iskomunidad
Revision as of 11:35, 23 April 2010 by Rsmoralejo (talk | contribs) (New page: ==Description== :Enables participants to design, implement and maintain process control systems; understand and control process parameters; and configure control systems with appropriate h...)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Description

Enables participants to design, implement and maintain process control systems; understand and control process parameters; and configure control systems with appropriate hardware and software.

Schedule

Apr. 24 – May 29 9:00 AM – 4:30 PM (5 Saturdays)

Fee

P9,000

COURSE OBJECTIVES

After the course, the participants will be able to:

  • Select the type of level and flow measurement, as well as the control valve applicable to a process situation.
  • Perform calculations required in level measurements, orifice sizing, control valve sizing and controller tuning.
  • Understand the application, hardware and software requirements and basic configuration techniques in distributed control systems (DCS).

COURSE CONTENT

The course has a total of 30 hours and will cover the following topics.

1.0 Level Measurements & Calculations

  • 1.1 Methods of level measurement
  • 1.2 Operation, application & installation
  • 1.3 Selection of measurement method
  • 1.4 Level measurement calculations

2.0Flowmeter Selection & Orifice Sizing

  • 2.1 Flow measurement methods
  • 2.2 Operation, application & installation
  • 2.3 Selection of measurement method
  • 2.4 Orifice sizing calculations

3.0 Control Valve Selection & Sizing

3.1 Control valve body types

3.2 Flow characteristics

3.3 Actuators & accessories

3.4 Valve noise

3.5 Valve selection guidelines

3.6 Valve flow coefficient

3.7 Valve sizing equations

4.0 Automatic Control & Tuning Techniques

4.1 Control principles

4.2 Process characteristics

4.3 Control actions

4.4 Control modes

4.5 Tuning calculations

4.6 Tuning simulation

5.0 DCS Fundamentals & Configuration

5.1 Evolution & development

5.2 Hardware requirements

5.3 Software requirements

5.4 Network requirements

5.5 Configuration techniques

6.0 Engineering Documentation




TARGET PARTICIPANTS


The course is open to holders of a Bachelor’s Degree in Mechanical, Electrical, Electronics, Industrial or Chemical Engineering; as well as to instructors of technical schools and industrial technicians. Knowledge of the basics of Instrumentation and Process Control is a prerequisite to the program.


TRAINING METHODOLOGY


The lecture-discussion method will be used and sufficiently supplemented by laboratory and simulation work, which is the hands-on portion of the program. The resource persons will supervise individual and group exercises closely.


VENUE


Sessions will be conducted at the Low-Cost Automation (LCA) Rooms of UPISSI.

Retrieved from "https://iskomunidad.upd.edu.ph/index.php?title=Advanced_Instrumentation_and_Process_Control_Course&oldid=11716"