Proximity Sensor via Ultrasonic Sonar Module

From Iskomunidad
Revision as of 06:17, 22 April 2014 by Chrismangarcia (talk | contribs)

Part of the Sensors and Controls Project, this Arduino micro-based Proximity Sensor integrates of an Ultrasonic Sonar module. With this, one can easily monitor if there's someone near or around a specific area, say, room, door, gate.


I. OBJECTIVES

  • To make an Arduino based Proximity sensor via Ultrasonic Sonar module
  • To simulate effectiveness by varying distances


II. MATERIALS & COMPONENTS

  • Arduino micro/ Arduino UNO

100 100


  • Ultrasonic Sonar Module (US-100)

100


  • Jumper wires

100


  • 5 (Light Emitting Diodes) LEDs

100


  • 6 330K ohms Resistors

100


  • Piezo Buzzer

100


  • Computer (with Arduino 1.0.5 Software)

200



III. PROCEDURES

1. Prepare all the materials.

2. Put the corresponding components onto the breadboard. Make sure that the pins of the components are properly put to ensure the efficiency of the circuit.

3. There are 5 pins of the US-100. From the back facing yourself, the 2 pins form the left are GROUND. The third pin from the left is the ECHO, followed by the TRIGGER and lastly, the rightmost one, the VCC or the power.

4. Connect the TRIGGER pin to Pin 6 of the Arduino micro. Connect the ECHO pin to Pin 7 of the Arduino micro.

5. Make a connection between the 2 GROUND pins and connect it to GROUND of the Arduino micro. Also connect the VCC or power to the 5V pin of the Arduino micro.

6. For the indication purposes, you will connect 3 LEDs and a small buzzer. The GROUND pins of the LEDs and buzzer will be connected to the GROUND pin of the US-100. The ANODE pins of LED1 to pin 8, LED2 to pin 9 and LED3 to pin 10.


IV. SIMULATION


V. OTHER PHOTOS


VI. REFERENCES

Retrieved from "https://iskomunidad.upd.edu.ph/index.php?title=Proximity_Sensor_via_Ultrasonic_Sonar_Module&oldid=41235"